Programming ACTA ACTA 4000 User Guide
68 (136) 2008-12 9836 4171 01
4.8.1 Zoom in and zoom out
This function zooms in to the area shown by the rectangle visible after selecting Zoom in. Use the soft key
arrows to position the rectangle on a specific area of the measurement curve. Then press
ENTER. The area
representing the rectangle now represents approximately the full display and the increments on the Y and
X axis change accordingly. To zoom further, simply select
Zoom in once again. You can zoom in on a
specific area on the trace up to five consecutive times.
When selecting
Zoom out, the original measurement curve returns.
4.8.2 Adjust position
This function is used to tune the measured value for the tightening. It lets you shift the position of
measured point along the tightening graph. When
Adjust position has been selected, use the soft key
arrows so move the cursor along the tightening graph to the desired measurement point. Confirm the new
values by pressing
ENTER. Now, the tightening is saved with the new values. To exit the adjust position
function without changing measurement values, simply press
Cancel. The adjusted tightening will be
marked as a manual input when transferred to ToolsTalk QAT.
4.8.3 Save trace
To save a trace in the database, select one of the resolution options in the Save trace pull-up menu. Low,
medium and high refers to which resolution the trace is saved in. The table below show approximately
how large a trace with given resolution is, given in fractions of the entire database.
Resolution Approximate memory space required
(fraction of database total memory)
1 Low
1/128
2 Medium
1/32
3 High
1/8
Upload of the tool database to ToolsTalk QAT also uploads the saved trace
information.
To Next Page
Loading...
