ACTA 4000 User Guide Programming ACTA
9836 4171 01 2008-12 35 (136)
4.4.1 All tightening
This window is actually a chain of three windows, displaying statistics on all tightening operations of the
selected tool. Use the soft key arrows to navigate through your tightening statistics. The right/left arrows
change statistical window as shown below. Press
Cancel to leave window.
The tightening operations are displayed with the first tightening operation shown on top.
If any parameter flashes it indicates that its result is outside the limits specified in menu
block Prog>Statistical setup
Menu item Description
All tightening 1 No.
Tightening number
Torque
Measured torque
Angle
Measured angle
Pulses
Measured no of pulses
Menu item Description
All tightening 2 No.
Tightening number
Torque
Measured torque
C Trq
Controller torque
Diff
Difference between measured torque and
controller torque
Menu item Description
All tightening 3 No.
Tightening number
Angle
Measured angle
C Ang
Controller angle
Diff
Difference between measured angle and
controller angle
All tightening 1
All tightening 2
All tightening 3
To Next Page
Loading...
