ACTA 4000 User Guide Programming ACTA
9836 4171 01 2008-12 27 (136)
Print menu, ACTA 3000 and ACTA 4000
1 Continuous
Starts a printout of the tightening result after each tightening
operation. The printout is in the form of a list. To stop continuous
printing, press the
Print soft key again. The Continuous list member
is now replaced by
Abort continuous. Select Abort continuous and
the printout ends (a footer and form feed is printed).
2 Tool rundowns
Prints all tightening operations for selected tools.
3 Transducer info
Prints transducer info for connected transducers.
4 Tool setup
Prints the setup for selected tools.
5 Tool statistics
Prints statistics for selected tools.
6 Tool calibration
Prints a calibration report for selected tools. A tool calibration should
have been performed prior to the printout.
7 ISO 5393
Prints ISO 5393 calibration report. An ISO 5393 calibration must
have been performed prior to the printout.
Print
1 Continuous
2 Tool rundowns
3 Transducer info
4 Tool setu
To Next Page
Loading...
