Icon Name Mode Function
Flashing + H3 Too high discharge
temperature of the
refrigerant compressor
(see further)
Dryer is stopped
Fan Off Fan off
Flashing Not applicable
On Fan on
Remote alarm function
Depending on the dryer model, the controller allows to remotely control a number of alarms. This is
managed by means of a free NC (Normally Closed) contact.
The contact opens in case of an alarm.
Refer to the table below to identify the availability of the function and refer to the related picture to identify
the physical location of the free contact.
Availability of the remote alarm function
Model Fault message availability
P1 P2 P3 L2 H2 H3
FX 13 to FX 16 no yes yes yes yes yes
Instruction book
18 2920 7112 50
To Next Page
Loading...
Need help?
General
