REMOTE ALARM FUNCTION
The controller allows to remotely control a number of alarms. This is managed by means of a free NC (Normally Closed)
contact.
The contact opens in case of an alarm or when the dryer is switched off.
Refer to the table below to identify the availability of the function and refer to the related picture Fig. 9a Ref. 1 to identify
the physical location of the free contact connector.
Is possible remote alarm for P1, P2, P3, L2, H2 and H3. For the details of alarm see Cap. 17.1 Pag. 12.
Location of the free contact connector (1)
To Next Page
Loading...