Atlas Copco ORKA 350/450 - Starting the Engine, Lombardini

4. Turn the engine start switch (E) to ON.
5. Grip the handle of the recoil starter (F) and pull
until resistance is felt. Release the handle to the
initial position, then pull until the engine starts.
6. Move the choke valve (G) gradually to the fully
open position.
NOTICE When you have started the engine, leave
it for a few minutes to warm up before loading the
generator.
Starting the engine, Lombardini
1. Set the engine ON/OFF control (A) to position
ON.
2. Set the throttle control (B) to half throttle.
A
B
3. Grip the recoil starter handle (C) with both hands
and pull until it resists. Return the handle to the
initial position, then pull sharply and at an
increasing speed (but do not jerk) until the engine
starts.
C
4. As the engine warms up, gradually move the
throttle control (D) to position MAX.
D
NOTICE Before use, the engine throttle control (D)
must be in MAX position.
© 2015 Construction Tools EOOD | No. 9800 1203 01b | 2015-02-05
Original instructions
14
ORKASafety and operating instructions