Atlas Copco P2000i Manual

STOPPING THE ENGINE
1. Disconnect any electric devices and turn the ESC switch to o󰀨 (1).
2. Turn the 3 in 1 switch to OFF (2).
3. Turn the fuel tank cap air vent knob to OFF (3) after the engine has
cooled down.
PORTABLE GENERATOR
BASIC INSTRUCTIONS
(Atlas Copco P2000i)
PRE-OPERATION CHECK
1. Check the engine oil level (4-stroke motor oil).
• Ensure the machine is o󰀨 and on a level surface.
• Remove the screws (1) and the oil ller cap (3).
• Fill with the specied amount of SAE 10W-30 oil.
2. Check the fuel level.
• Remove the fuel tank cap and ll to the red mark (1) to achieve
the correct fuel level (2).
STARTING THE ENGINE
1. Before starting, ensure the ESC switch is OFF (1).
2. Turn the air vent knob to on (2).
3. Turn the three in one switch to “CHOCK“ (3).
4. Pull slowly on the recoil starter until it is engaged, then pull it briskly.
Hold the carrying handle with one hand to prevent the unit falling over.
5. Warm up the engine until it does not stop if the chocke knob is
returned to the “ON“ position (4).
MAIN COMPONENTS

Atlas Copco P2000i Specifications

General

Brand	Atlas Copco
Model	P2000i
Category	Portable Generator
Language	English