Atlas Copco PHE 45 S - Page 11

10
PAGE
Repair Instructions No.189.03/01
PHE 45 S
Mounting the
electric
components
1 Insert a sleeve (4) into the handle shell (A)
and fit the handle shell to the motor housing.
2 Mount the second sleeve (4) , the elec-
tronic element (1), and the switch
board (C) in the handle (6).
3 Wire the switch connections. See illustra-
tion on the right and the circuit diagram
below.
4 Lay the connection cable (E) with the pro-
tection cover (F) in the handle shell (6)
and connect it with the switch (C).
5 Put the handle (6) with the holding down de-
vice (3) on the other half of the handle (A).
6 Fit the soft grip (8) and fix it with the screw (9).
7 Insert the knurled nut (5) into the handle
shell (6).
8 Fasten the secured handle screw (B) to
the handle shell (A) while steadying the
knurled nut (5).
9 Insert two screws (D) with the discs and
fasten them.
a
e
f
d
d
f
b
c
a
b
6
5
4
3
2
7
8 9
A
B
E
F
C
4
1
D
8
2
9
8
7
4
3
1
1
4
2
7
8
1
2
5
6
?
Electronics
Assembly
Inductor
Boat
WIRING
SCHEMATIC
7
8
1
2
4
5
3
6
9
5
6
Wire
No.
Wire Colour from to
110 V 120 V 230 V
1 blue white blue mains switch
2 brown black brown mains switch
3 red red red field guide 9
4 red red red field switch
5 yellow yellow yellow field brush holder
6 black black black black brush holder
7 white black black motor control switch
8 black black black motor control switch
9 black blue red motor control guide 3
Wiring diagram
Circuit diagram