11
PAGE
Repair Instructions No.189.03/01
PHE 45 S
Mounting the
armature
1 Push the plug (5) over the armature (6)
and press the fan (7) onto the arma-
ture (6). Press the ball bearing (8) as well
as the ball bearing (4) over the armature.
Push the bearing bush (9) over the ball
bearing (8).
2 Insert the armature (6) completely with the
fan (7) into the motor housing (3) by turn-
ing and at the same time depressing it.
3 Insert the brush holder (E) into the motor
housing from the side (3) (mind the right
position!) and fasten them.
4 Insert the carbon brushes (D) with the
cable lugs (1) and (C) into the brush hold-
er (E).
5 Connect the cable lugs (1) and (C) with
the field.
6 Mount the brush springs (2) in the brush
holder (E). Pull the brush springs (2) aside
at their hooks and pull them over the car-
bon brushes (D).
7 Fit the motor housing cap (A) and fasten it
with the four secured screws (B).
Mounting the
switch knob
1 Fit the torsion spring (8) to the shift pin (7)
such that it is located in the boring of the
shift pin (7).
2 Insert the shift pin (7) with the torsion
spring (8) into the gear box insulation (3).
3 Mount the ball (2), the pressure spring (1)
and the switch knob (9) from the outside in
the gear box insulation (3).
4 Insert the O-ring (5) into the gear box insu-
lation (3) and mount the locking ring (4)
with aid of special pliers.
5 Fit the gear box insulation (3) to the
machine and secure it with the four
screws (6).
☞
Take care that the pin (7) grasps the
groove in the indexing sleeve (D)
(see page 7, ill. 2, part (D)).
1
6
5
4
3
2
7
8
9
A
B
C
DED
1
6
5
4
3
2
7
8
9
To Next Page
Loading...