5
Safety instructions
To reduce the risk of serious injury or death to yourself or others, carefully read
through this instruction booklet before putting the pick hammer to use. Always
follow the instructions given in this manual.
h Always wear a safety helmet, impact resistant eye protection with side protection
and ear protectors during breaking. Any local regulations that exist must also be
observed.
h When breaking in certain minerals, there is a risk of spark generation. Before
starting work, check that the machine is approved (in accordance with local
regulations) for work under such conditions.
h Always take great care when using the machine. The insertion tool is subjected to
heavy loading and can break, with a risk of injury to personnel.
h Check that the hoses used are of the right quality, and that all hose connections
are in good condition and properly tightened.
h Before starting work on any of the systems, make sure that the air and water
systems are un-pressurized.
h The machine is not electrically insulated. If the machine comes into contact
with electricity serious injuries or death may result. To reduce the risk of such
injury or death, never operate the machine near any electric wire or other source
of electricity. Make sure that there are no concealed wires or other sources of
electricity.
h Exposure to crystalline silica (sometimes called 'silica dust') as a result of
breaking in rock may cause silicosis, cancer or death. To reduce silica exposure,
use respiratory protective equipment.
h A compressed air hose that comes loose can lash around and cause personal
injury or death. Check that the compressed air connections are not damaged and
that they are properly attached.
To Next Page
Loading...