Overview
To reduce the risk of serious injury or death to
yourself or others, read the Safety instructions
section found on the previous pages of this
manual before operating the machine.
Design and function
TEX 3, 05P, 09PS, 10PS and 12PS are machines
designed for light demolition and construction work.
The machines can be used both horizontally and
vertically. No other use is permitted.
Recommended insertion tools are listed in the spare
parts list.
Choosing the correct
pneumatic hammer for a task
It is important to choose the correct size of pneumatic
hammer for the work to be performed.
A pneumatic hammer that is too small means that
the work will take longer.
A hammer that is too big means that there must be
frequent repositioning, which is unnecessarily tiring
for the operator.
A simple rule for choosing the correct size of
pneumatic hammer is that a normal sized piece of
broken material should be removed from the
workpiece within 5–10 seconds operation.
● If it takes less than 5 seconds a smaller pneumatic
hammer should be selected.
● If it takes more than 10 seconds a larger
pneumatic hammer should be selected.
Main parts
TEX 3TEX 05P
TEX 09PS
13© 2010 Atlas Copco Construction Tools AB | No. 9800 0799 90 | 2010-01-01
Original instructions
Safety and operating instructionsTEX 3, 05P, 09PS, 10PS, 12PS
To Next Page
Loading...
Need help?
General
