EasyManuals Logo

Atlas Copco TEX P User Manual

Atlas Copco TEX P
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Main parts of the machine
1. Air inlet
2. Oil filler plug
3. Handle
4. Silencer, Type PS, PE
5. Air valve/trigger
6. Bolt (350 Nm)
7. Front head
8. Tool retainer
9. Machine ID plate (always state machine type
and serial No. when ordering spare parts).
Precautions before starting
!
WARNING
To maintain correct function of the machine,
always replace worn or damaged parts.
!
CAUTION
Before removing the oil plug, switch off the
air supply and vent the machine, otherwise
oil may squirt into your face.
The machine is equipped with a built-in lubricator.
Lubricating oil is essential for good machine func
-
tion and service life.
Use synthetic air-tool oil type AIR-OIL, or mineral
base oil.
Make it a rule to fill the oil container with the re
-
commended oil daily.
Lubricant
Temperature
range °C
Viscosity grade
Synthetic oil
AIR-OIL
-30 to +50 ISO VG 46 - 100
Mineral
base oil
+15 to +35 ISO VG 46 - 100
-20 to +15 ISO VG 32 - 46
N.B. When checking the oil level or filling with oil, the
machine must be in the vertical position.
First clean around the oil filler plug, then screw
out the plug.
Fill with the recommended oil up to the "lowest"
thread, then fit back and tighten the plug.
Check that the compressed-air hose and fittings
are not damaged, and that all compressed-air
connections are properly attached.
Choose the correct size and length of hose.
Make sure that you have the correct working
pressure max. 7 bar (e).
Before connecting the compressed-air hose to
the machine, blow through it with compressed air
to remove any foreign matter.
Choose the correct tool and shank size. When in
-
serting certain tools, you must align the hexago
-
nal shank so that the tool has the correct working
angle.
Open the tool retainer. Insert the tool. Close the
retainer.
3
English
Safety regulations English
These instructions contain important sections dealing with safety.
Special attention must be paid to all framed safety text that begins with a warning symbol (triangle) followed
by a signal word, as shown below
!
WARNING
denotes a hazard or hazardous procedure which CAN lead to
serious or life-threatening injuries if the warning is not
observed.
!
CAUTION
denotes a risk or risky procedure which CAN lead to personal
injury or damage to equipment if the caution is not observed.
Also observe the following general safety rules:
Before starting the machine, read through these instructions carefully.
Also read through the red safety instructions before putting the machine to use.
For reasons of product safety, the machine must not be modified.
Use approved personal protective equipment.
Use Atlas Copco Genuine Parts only.
Replace damaged or worn plates.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Atlas Copco TEX P and is the answer not in the manual?

Atlas Copco TEX P Specifications

General IconGeneral
BrandAtlas Copco
ModelTEX P
CategoryTools
LanguageEnglish

Related product manuals