Atlas Equipment OH-10X User Manual (English)

Other manuals for Atlas Equipment OH-10X

Questions and Answers:

D
Darrell RuizAug 4, 2025
Why motor does not run on Atlas Equipment Lifting Systems?
- C
  Catherine WilliamsAug 4, 2025
  If the motor of your Atlas Equipment Lifting System doesn't run, it could be due to several reasons. First, the button might not be working, in which case you should replace it. Another potential cause is poor wiring connections; repair all wiring connections to resolve this. The motor itself could be burned out, requiring repair or replacement. A damaged Height Limit Switch or a burned-out AC Contactor could also be the culprit; replacing these components may solve the issue.
Q
qavilaAug 10, 2025
What to do if Atlas Equipment OH-10X Lifting Systems raises slowly?
- P
  paulmcgeeAug 10, 2025
  If your Atlas Equipment Lifting System raises slowly, several factors could be responsible. A jammed oil line can restrict flow, so cleaning the oil line is recommended. Low voltage to the motor can also cause slow lifting; check the electrical system. Air mixed with the oil can reduce hydraulic efficiency, so fill the tank. A leaking gear pump will cause a pressure drop, so replace the pump. Finally, overloading the lift beyond its capacity will cause it to raise slowly, so check the load.
A
Amy BrennanAug 15, 2025
What to do if motor runs but the lift is not raised in Atlas Equipment OH-10X Lifting Systems?
- J
  Jason CrossAug 15, 2025
  If the motor runs but your Atlas Equipment Lifting System isn't raising, here's what might be happening: * The motor could be running in reverse; reverse two power wires. * The gear pump might be out of operation; repair or replace it. * The release valve may be damaged; repair or replace it. * The relief or check valve could also be damaged; repair or replace them. * The oil level might be low; fill the tank.