Need help?Do you have a question about the Atlas 804 and is the answer not in the manual?
Dipping the first few threads in light oil every several installations to reduce wear.
All air tools containing gears should be lubricated weekly with standard gear grease.
Air tools should be flushed weekly with a solution of three parts cleaning solvent and one part oil.
Pneumatic tools have sensitive internal components and need to be treated as such.
Importance of a regulated supply line to prevent complications with high pressures and overloads.
High tool power causes stripped threads; reduce air pressure to resolve.
High tool power causes broken studs; reduce air pressure to resolve.
Perform sample installations at various pressures to find optimal setting.
Adjust supply line pressure while the tool is running with no part on the tool.
Guidelines on using tool sizes for larger or smaller parts, and limitations.
Information on how often to perform preventive maintenance on the tool.
Replace cap screws or bearings when excessive wear is observed.
Guidance on self-repair, warranty implications, and potential damage.
How to find parts lists and breakdowns for the tool.
Steps to follow when sending the tool in for repairs.
To Next Page
General