What to do if there is no sound from my Atlas Speaker System?
If there's no sound, first ensure all equipment in the system is powered on. Verify that the routing (input/output) controls are correctly set and the volume level isn't too low. Also, check the entire system for crossed wires or loose connections, paying special attention to the AH location for correct connections.
Why is my Atlas Speaker System sound cutting in and out?
Sound cutting in and out can be due to a system overload, oscillation, or an intermittent connection. Check for any overload conditions or bad connections within the system.
How to fix distortion at increased levels on my Atlas Speaker System?
If you're experiencing distortion at increased levels, it could be that the amplifier or speaker is being overdriven. Ensure the power to the speaker isn't exceeding its limits and that the amplifier isn't being overdriven. Try slightly reducing the power to the amplifier.
What to do if my Atlas Speaker System has low sound level?
If the sound level is low, check the volume levels on your amplifiers and related equipment, such as the equalizer. Also, inspect the connections to ensure they aren't partially shorted or corroded.
Why does my Atlas Speaker System make a buzzing noise?
A buzzing noise from the speaker could indicate loose hardware or speaker damage. Make sure the speaker grille is tight and check all other hardware connections. Inspect the speakers for any loose parts or signs of damage.
To Next Page
General