Rev:A0 80531
Cautions:
1.Do not use the electric generator to test the LED light.
2.Please abide by related country, regional and local law and regulations when install this light.
3.Please turn off the power before installation or maintenance.
4.Proper grounding is required to ensure safety.
Notice:
1.To avoid possibility of electrical shock or fire, the installation personnel must have
professional electric knowledge.
2.Please wear gloves to avoid injury before installation.
3.If any smoke or spark of the wire happened, please turn off the power immediately and
notify relevant personnel.
Attention:
1.Please check if there is any damage during shipping. If so, please contact manufacturer
timely.
2.Please read the installation instruction carefully to check whether all the accessories are
available. After confirmation, install the fixture according to installation steps.
Installation instruction
1.Turn power off before installation
(Figure 1).
2.Secure the mounting bracket to the
junction box with appropriate screws
(Figure 2).
This installation instruction applies to the following products. Although the products vary in
appearance, their installation steps are the same.
3.Attach the pad on the bottom of the light,
and hang the light on the bracket through
the hanging rope(Figure 3).
Figure 1
Figure 2
page 1
Figure 3
4.Connect the wires to the main properly
and make good protection(Figure 4).
Figure 4
Black:ACL
Green:
White:ACN
6.Put the rubber cap back(Figure 6).
Figure 6
5.Remove the rubber cap and fasten the
light to the bracket with screws
(Figure 5).
Figure 5
7.Make sure installation is complete before
turning on the power(Figure 7).
8. After installation,calk all the mounting
surface.
Figure 7
page 2
Installation Instruction
Origin Series by Atlas Lighting | 1406 S. Mebane St. | Burlington, NC 27215 | 800-849-8485 | www.atlasled.com Origin Series by Atlas Lighting | 1406 S. Mebane St. | Burlington, NC 27215 | 800-849-8485 | www.atlasled.com
LED Motion Light Instruction
To Next Page
Need help?
General
