Atlas origin Series User Manual

LED Flood Light
ORBSEL
SAVE THESE INSTRUCTIONS
BEFORE YOU BEGIN
Read and follow all safety instructions
WARNING
RISK OF FIRE, EXPLOSION AND ELECTRIC SHOCK
• This product should be installed, inspected, and maintained by a qualified electrician only,
in accordance with the NEC (National Electric Code) and all local codes.
• Turn off electrical power before inspection, installation or removal.
• Use only UL (or other NTRL) approved wire for input/output connections.
Minimum size 18 AWG or 14 AWG for continuous runs.
• Make sure LEDs and drivers are cool to touch when performing maintenance.
Make sure the supply voltage is the same as the rated voltage of the luminaire.
• Do not install in a hazardous atmosphere, except where the ambient temperature does
not exceed the rated operating temperature of the fixture.
• Keep tightly closed when in operation.
Prepare Electrical Wiring
Electrical Requirements
Grounding Instructions
The grounding and bonding of the overall system shall be
done in accordance with NEC Article 600 and local codes.
The LED driver must be supplied with the voltage specified on the product label
and connected to an individual, properly grounded branch circuit protected by a 20
Ampere circuit breaker. Use min. 75°C supply.
Installation Instruction
06.23
Origin Series by Atlas Lighting | 1406 S. Mebane St. | Burlington, NC 27215 | 800-849-8485 | www.atlasled.com

Atlas origin Series Specifications

General

Category	Flood Light
Beam Angle	120°
IP Rating	IP65
Power	100W
Color Temperature	3000K
Input Voltage	AC100-240V
Lifespan	50000 hours
Material	Aluminum
Weight	Varies by wattage, see datasheet

Summary

Before You Begin

General Safety Precautions

Essential safety warnings regarding installation, power, wiring, and operating conditions for the LED flood light.

Electrical Requirements

Specifies voltage, grounding, and circuit breaker requirements for the LED driver connection.

Grounding Instructions

Details on grounding and bonding the system according to NEC Article 600 and local codes.

Standard Installation

Pre-Installation Checks

Verify power is off and fixture is undamaged before proceeding with installation.

Wiring and Fixture Mounting

Connect power and dimming wires, secure fixture to junction box or conduit.

Fixture Aiming and Final Check

Adjust fixture angle using the screw and confirm proper operation after restoring power.

Adjusting Fixture Settings

CCT and Wattage Selector Access

How to access and adjust the slide switch for desired Color Correlated Temperature (CCT).

Photocontrol Adjustment

Instructions to enable or disable the photocontrol by adjusting its back-side switch.

Tunable Settings Guide

Guide for adjusting three-position slide switches for CCT (5000K, 4000K, 3000K) and wattage.

Electrical Wiring Diagram