11. Run the Cabinet for at least four (4) complete 15 minute wash cycles over the next
two days. The goal of this is to thoroughly coat the inside of the Cabinet with the Rust
Inhibitors contained in the recommended style of Detergent. This will help keep the
inside of the Cabinet free of rust between washes. You may clean parts after completing
the initial 15 minute wash cycle.
12. Do not allow sludge to accumulate and exceed a 1” depth. Clean this sludge from the
tank within the rst week (See Instruction Manual). If you are cleaning the same parts
each time, you will get a good idea of how often you need to remove the sludge from
your machine. You will also be able to determine the type of cleaning solution and
length of run time needed. More complete instructions are located in your Installation
and Operation Manual.
If you are going to let the machine sit unused, for any extended
period of time, SPRAY COAT the inside surfaces with WD40 or
recovered oil from skimmer to assure rust does not develop.
To Previous Page
Loading...
Need help?
General
