Why does the turntable on my Atlas Tyre Changer only rotate in one direction?
If the turntable on your Atlas Tyre Changer only rotates in one direction, it's likely that the reverser is broken. The suggested solution is to replace the reverser.
General| Force on bead breaker blade (10 bar) | 2500 kg |
|---|---|
| Inflating pressure device max. | 3.5 bar (50 psi) |
| Max spindle torch | 885 ft/lbs |
| Working pressure | 10 bar (145 psi) |
| Noise level in working condition | < 70 dB (A) |
| Power supply voltage | 110V 1Ph |
| Motor power | 1.1 kw (1ph) |
Weight and Dimensions| External locking rim dimension | 11 7/8" - 26" 12 7/8" - 27" 13 3/4" - 28" |
|---|---|
| Internal locking rim dimension | 13 7/8" - 27 7/8 14 5/8" - 28 7/8" 15 5/8" - 29 7/8" |
| Max. tire diameter | 1200mm (47.5”) |
| Max tire width | 470mm (18.5”) |
| Dimension | 1140 x 1100 x 950 |
| Net weight | 240 kg STND |
Essential safety guidelines for operating the tire changer.
Illustrates and explains various safety and danger symbols used in the manual.
Procedures for final electrical/pneumatic setup, initial testing, and operating tests.
Detailed steps for safely breaking the tire bead from the rim.
Procedures for safely removing the tire from the rim using the machine.
Steps for mounting a new tire onto the rim using the tire changer.
Step-by-step guide for inflating tires safely, including warnings about pressure.
A table listing common problems, their possible causes, and recommended solutions.
To Next Page