ATLET 110781 - Page 45


EElleeccttrriiccaal l ssyysstteemm 1100..4455
EErrrroor r ccooddeess AATTLLEET T SSEERRVVIICCE E MMAANNUUAALL
E49E49
(software(software
3.60–)3.60–)
AcceleratorAccelerator
errerr
Sensor toSensor to
highhigh
Accelerator sensor valueAccelerator sensor value
is higher than allowed.is higher than allowed.
Calibrate and checkCalibrate and check
the accelerator. Seethe accelerator. See
chapter 11 forchapter 11 for
instructions.instructions.
EE5500 NNoot t uusseedd NNoot t uusseedd..
EE5511 FF6 6 FFuussee
brokenbroken
FFuusse e FF6 6 bbrrookkeenn.. CChheecck k ffuusse e FF6 6 aanndd
connections.connections.
EE5522 FF7 7 FFuussee
brokenbroken
FFuusse e ff7 7 bbrrookkeenn.. CChheecck k ffuusse e FF7 7 aanndd
connections.connections.
EE5533 FF8 8 FFuussee
brokenbroken
FFuusse e FF8 8 bbrrookkeenn.. CChheecck k ffuusse e FF8 8 aanndd
connections.connections.
EE5544** CCaasstteerr
wheelwheel
rotationrotation
locklock
Reported current to mainReported current to main
brake or caster wheelbrake or caster wheel
rotation lock is higher orrotation lock is higher or
lower than expected.lower than expected.
See separateSee separate
description. Seedescription. See
chapter 10.3.4.chapter 10.3.4.
EE5555** SS3 3 ssyysstteem m 11
err.err.
NoNo
checkswitchcheckswitch
during liftduring lift
No checkswitch (S16)No checkswitch (S16)
when ifting passed 4.5 m.when ifting passed 4.5 m.
Check that theCheck that the
checkswitch (S16)checkswitch (S16)
is adjusted to 4500is adjusted to 4500
+/- 10mm. Check+/- 10mm. Check
that thethat the
checkswitch closescheckswitch closes
when affected buwhen affected bu
magnet. Check themagnet. Check the
height measuringheight measuring
system (A24 &system (A24 &
A26). Check thatA26). Check that
the “Height offset”the “Height offset”
is correctly set.is correctly set.
NoNo
checkswitchcheckswitch
duringduring
loweringlowering
No checkswitch (S16)No checkswitch (S16)
when lowering passed 4.5when lowering passed 4.5
m.m.
Check that theCheck that the
checkswitch (S16)checkswitch (S16)
is adjusted to 4500is adjusted to 4500
+/- 10mm. Check+/- 10mm. Check
that thethat the
checkswitch closescheckswitch closes
when affected bywhen affected by
magnet. Check themagnet. Check the
height measuringheight measuring
system (A24 &system (A24 &
A26). Check thatA26). Check that
the “Height offset”the “Height offset”
is correctly set.is correctly set.
ErrorError
codecode
ErrorError
messagesmessages
SSuubbiinnffoo DDeessccrriippttiioonn IInnssppeeccttiioonn/ / 
Corrective actionCorrective action
https://www.besttruckmanuals.com/