10.46 10.46 Electrical Electrical systemsystem
AATTLLEET T SSEERRVVIICCE E MMAANNUUAALL EErrrroor r ccooddeess
BadBad
forkheightforkheight
atat
checkswitchcheckswitch
Wrong height value whenWrong height value when
checkswitch (S16) ischeckswitch (S16) is
passed.passed.
Check that theCheck that the
checkswitch (S16)checkswitch (S16)
is adjusted to 4500is adjusted to 4500
+/- 10mm. Check+/- 10mm. Check
that thethat the
checkswitch closescheckswitch closes
when affected bywhen affected by
magnet. Check themagnet. Check the
height measuringheight measuring
system (A24 &system (A24 &
A26). Check thatA26). Check that
the “Height offset”the “Height offset”
is correctly set.is correctly set.
Reach stopReach stop
switchswitch
timeouttimeout
Reach stop switch (S5) isReach stop switch (S5) is
not closed in tilme atnot closed in tilme at
reach out.reach out.
Check the reachCheck the reach
stop switch (S5)stop switch (S5)
function.function.
Contradict.Contradict.
load wheelload wheel
sensorssensors
Both UFS rotating whellBoth UFS rotating whell
stops (S45 and S44) arestops (S45 and S44) are
closed at the same time.closed at the same time.
Check the rotatingCheck the rotating
wheel and stopwheel and stop
switches function.switches function.
Contradict.Contradict.
zero andzero and
low fork sw.low fork sw.
Conflict between the LZConflict between the LZ
and LF switches.and LF switches.
ContradictContradict
zero andzero and
checkcheck
switchswitch
Conflict between the LZConflict between the LZ
and CS switches.and CS switches.
ContradictContradict
LF andLF and
checkcheck
switchswitch
Conflict between the LFConflict between the LF
and CS switches.and CS switches.
EE5566 NNoot t uusseedd NNoot t uusseedd..
EE5577 NNoot t uusseedd NNoot t uusseedd..
EE5588 NNoot t uusseedd NNoot t uusseedd..
EE5599 TTeesstt
commoncommon
errorerror
The not fully developedThe not fully developed
cable supervision optioncable supervision option
is set to on. A true or falseis set to on. A true or false
fault is indicated.fault is indicated.
Set option “SystemSet option “System
supervis.” to No.supervis.” to No.
EE6600 WWhheeeell
angle sensorangle sensor
FBWFBW
EE6611 RRoottaattiioonn
sensor.sensor.
FBWFBW
EE6622** FFaauulltty y iinnppuutt
from S8from S8
WGU only. IndicatesanWGU only. Indicatesan
illegal combination of theillegal combination of the
inputs from the S8 switchinputs from the S8 switch
(WGU auto/manual(WGU auto/manual
button).button).
Check the S8Check the S8
switch and it´sswitch and it´s
connections.connections.
ErrorError
codecode
ErrorError
messagesmessages
SSuubbiinnffoo DDeessccrriippttiioonn IInnssppeeccttiioonn/ /
Corrective actionCorrective action
To Next Page
Loading...