MaMast st sysyststem / em / ReRepapair ir iinsnstrtrucuctitionons / s / FoFork rk cacarrrriaiagege, t, telelesescocopipic fc foorkrks, s, TTFF 6.6.2727
Fork carriage, telescopic forks, TFFork carriage, telescopic forks, TF
Dismantling the fork carriage TFDismantling the fork carriage TF
The fork carriage only needs to be lifted out of The fork carriage only needs to be lifted out of the frame when replacing fork carriagethe frame when replacing fork carriage
rollers. Trollers. To lift out, see the o lift out, see the instructions for dismantling the type of frame the truck isinstructions for dismantling the type of frame the truck is
equipped with.equipped with.
1.1. Lift the Lift the fork cfork carriagarriage to a e to a suitasuitable heble height ight to disto dismantlmantle the e the overover-cog-cogging pging protecrotectiontion
on the back of the fork carriage, see fion the back of the fork carriage, see figuregure6.296.29..
2.2. Lower Lower the forthe fork cak carriage rriage to a to a suitabsuitable hle heigheight to at to achiechieve a ve a comfcomfortabortable wole workingrking
position, and make sure that the forks are fully withdrawn.position, and make sure that the forks are fully withdrawn.
3.3. Pull tPull the bahe battery pttery plug oulug out from tt from the ehe electrilectrical pcal panel panel plug tlug to diso disconnconnect thect the powe power toer to
the electrical system.the electrical system.
4.4. ReleaRelease thse the flexe flexible ible cablcable to the to the fore fork drivk drive motoe motor by lr by loosenoosening thing the two e two nuts tnuts thathat
hold the motor end hold the motor end head, and then remove the cables connections to the head, and then remove the cables connections to the motormotor..
Figure 6.29Figure 6.29 Over-cogging protectionOver-cogging protection
06_016-1_A-Ergo_ TFgafflar.eps06_016-1_A-Ergo_ TFgafflar.eps
To Next Page
Loading...