MMasast t ssysystetem m / / ReRepapaiir r ininststrruuctctiioonns / s / SiSidde e ststaabbililiisesersrs 66.3.377
Side Side stabilisestabilisersrs
Checking the side stabiliserChecking the side stabiliser
1.1. PlPlacace te the he trtrucuck ok on a n a lelevevel sl surfurfacace.e.
2.2. Fix a Fix a tape mtape measureasure with e with the zethe zero at thro at the top e top edge edge of onof one forke fork. Lift u. Lift until thntil the stabe stabiliseiliserr
switch in the mast breaks, i.e. until the switch in the mast breaks, i.e. until the mast stops, and measure the height. Liftmast stops, and measure the height. Lift
height should be at 3000 mm +/- 25 mm.height should be at 3000 mm +/- 25 mm.
3.3. ExtenExtend the d the stabistabilisers lisers until thuntil the moe motor sttor stops. Cops. Check heck that that the whthe wheels eels are prare pressedessed
against the floor against the floor and check the residual suspension. See table 6.6.and check the residual suspension. See table 6.6.
Adjusting the length of side stabilisersAdjusting the length of side stabilisers
•• MecMechanhanicaical adl adjustjustmenment is mt is made ade by aby adjudjustisting thng the loe lower ewer end ond of the f the pispistonton..
Table 6.6Table 6.6 Reference values for side stabilisersReference values for side stabilisers
Reference values for side stabilisersReference values for side stabilisers
When the stabilisers are extended at full speed the spring should compressWhen the stabilisers are extended at full speed the spring should compress
4-9 mm, when the pump motor has stopped. Irregularities in the floor are4-9 mm, when the pump motor has stopped. Irregularities in the floor are
absorbed by the spring in the top of the cylinder, see figureabsorbed by the spring in the top of the cylinder, see figure 6.386.38below.below.
Residual suspension with fully extended stabilisers and aResidual suspension with fully extended stabilisers and a
level flevel floorloor..
5-10 mm5-10 mm
Figure 6.38Figure 6.38 Check points for side stabilisersCheck points for side stabilisers
06_003_A-Ergo_SidoStab.eps
06_003_A-Ergo_SidoStab.eps
To Next Page
Loading...