îî
HyHydrdrauaulilic c sysyststem em / R/ Repepaiair r ininststruructctioions ns / / HyHydrdrauaulilic c oioil, l, chchanangigingng/d/drarainininingg 8.8.1717
ProcedureProcedure
1.1. LowLower doer down the fwn the forkorks and ds and discisconnonnecect the bat the battettery elery electrctricaicallylly..
2.2. Lift up Lift up the sthe steerinteering wheg wheel pel panel anel and pand pull oull out thut the mace machine hine houshousing cing coverover..
3.3. Check Check how mhow much ouch oil neil needs to eds to be fibe filled lled by cheby checkincking the og the oil leveil level (the l (the level level diffediffersrs
between different truck variants).between different truck variants).
4.4. Lower Lower the forthe forks to tks to their lheir lowest powest positioosition ann and discd disconneonnect the bct the batterattery elecy electricaltricallyly..
5.5. PlaPlace ce the the tratray on y on the the floofloor ber behinhind td the the truruck.ck.
6.6. Clamp Clamp the sthe suctiouction pipe n pipe betwbetween theen the pump e pump and taand tank, rnk, releaselease the se the suctiouction hon hose fromse from
the pump and lead it to the the pump and lead it to the traytray, and then release the clamp so that the oil , and then release the clamp so that the oil runs out.runs out.
Important!îImportant!î
Make sure that the oil does not overflow in the tray. The oil should be taken care ofMake sure that the oil does not overflow in the tray. The oil should be taken care of
in accordance with environmental legislation.in accordance with environmental legislation.
Filters are always replaced when changing the oil!Filters are always replaced when changing the oil!
7.7. ReplaReplace thce the suce suction tion pipepipe, and f, and fill up ill up with with new onew oil throil through ugh the hthe hydrauydraulic oil lic oil filter filter toto
the same level as before. If tthe same level as before. If there has been any leakage it will here has been any leakage it will be necessary to fill tobe necessary to fill to
a higher level than before. a higher level than before. TTo obtain the correct oil o obtain the correct oil level all the cylinders should belevel all the cylinders should be
run to their run to their end positions, and check that the end positions, and check that the pump does not suck air.pump does not suck air.
8.8. Run iRun in the n the cylincylinders ders and cand check heck that that the othe oil tail tank dnk does noes not oot overfverflowlow..
Note!îNote!î
The hydraulic oil should be filtered when filling, by pouring the oil throughThe hydraulic oil should be filtered when filling, by pouring the oil through
thethe filfilterter..
9.9. Wipe Wipe up anup any spiy spilled lled oil, coil, close lose the mthe machine achine houshousing cing coverover, and , and lower lower down tdown thehe
steering wheel panel.steering wheel panel.
To Next Page
Loading...