SeSerrvivice ce / S/ Sppeeciciffiic ic insnstrtruuctctioionns / s / LiLifft ct chahaiinns as annd fd foorrksks 33..2211
ATLET SERVICE MANUAL A-ERGOATLET SERVICE MANUAL A-ERGO
Lift chains and forksLift chains and forks
CheckCheck
For safety reasons the forks and all lift For safety reasons the forks and all lift chains should checked during eachains should checked during each service.ch service.
If a lift If a lift chain fails to be approved in any respect, the complete chain must be replaced;chain fails to be approved in any respect, the complete chain must be replaced;
and it is not permitted to and it is not permitted to replace parts of a lift chain.replace parts of a lift chain.
Important!Important!
If the lift cIf the lift chain fails to be approved in any respect the complete chain must behain fails to be approved in any respect the complete chain must be
replaced.replaced.
See under section 6 See under section 6 for instructions concerning checking chains and forks.for instructions concerning checking chains and forks.
Regular maintenanceRegular maintenance
The chain should be kept clean.The chain should be kept clean.
Lubricant (seeLubricant (see “Check list, service inspektion” on page 3.7“Check list, service inspektion” on page 3.7) must be regularly applied) must be regularly applied
onon the chain sthe chain so that all working suo that all working surfaces are continuously rfaces are continuously lubricated.lubricated.
The chain should be kept in motion when lubricating to ensure that the lubricantThe chain should be kept in motion when lubricating to ensure that the lubricant
penetrates the working surfaces between the link plates penetrates the working surfaces between the link plates and pins. All excess lubricantand pins. All excess lubricant
should wiped off, but solvent must should wiped off, but solvent must not be used.not be used.
If the chain runs dry it If the chain runs dry it should be lubricated more often; this also applies if the should be lubricated more often; this also applies if the truck istruck is
working in special environments such as cold stworking in special environments such as cold stores, etc.ores, etc.
Overhead guardOverhead guard
First serviceFirst service
1.1. The atThe attachtachment ment betwebetween then the ovee overhead rhead guarguard and cd and chasshassis shis should ould be retbe retighteightenedned
during the first service.during the first service.
2.2. The tiThe tighteghtening ning torqutorque bee between tween the othe overhverhead ead guard guard and and chasschassis shois should uld bebe
81 Nm.81 Nm.
Forks and liftForks and lift
chains shouldchains should
be checkedbe checked
during eachduring each
serviceservice
ee gg een nn ngg
after 200 hourafter 200 hour
ss
TighteningTightening
torque:torque:
81 Nm81 Nm
To Next Page
Loading...