MaMast st sysyststeem / m / ReReppaaiir ir innststrrucuctitioonns / s / DDiismsmaanntltliinng tg thhe me maastst 66..1177
10.10. Lift the inneLift the inner mast strr mast straight up unaight up until the lowetil the lower thrust rolr thrust roller on the innler on the inner maser mast and thet and the
upper thrust roller on the intermediate mast meet, and then pull upper thrust roller on the intermediate mast meet, and then pull the inner mastthe inner mast
forwards to release it from the intermediate mast. If the ceiling is too low dismantleforwards to release it from the intermediate mast. If the ceiling is too low dismantle
the mast,the mast, see "Dismantle the mast/straddle legs from the chassis" on page 6.8see "Dismantle the mast/straddle legs from the chassis" on page 6.8, and, and
set it down.set it down.
1111.. RemovRemove the uppe the upper retaier retaining scning screws for threws for the side cye side cylindelinders.rs.
12.12. Lift out thLift out the interme intermediatediate mast in the mast in the same wae same way as the iny as the inner masner mast.t.
13.13. The tighThe tightenintening torque betg torque between the framween the frame and machie and machine housne housing when refiing when refittingtting
should be 277 Nm.should be 277 Nm.
Figure 6.20Figure 6.20 Position for dismantling intermediate mastsPosition for dismantling intermediate masts
2
2
11
06_012_A-Ergo_ DelaMast.eps06_012_A-Ergo_ DelaMast.eps
TighteningTightening
torque:torque:
272777 NmNm
To Next Page
Loading...