EN
www.atmos.cz
80-EN
Operation and maintenance manual - EN
14 ALARM MODUL
disfunction of
AC07X-C
module for pneumatic ash
cleaning system or other devices
Check the connector between
AC07X-C and AC07X
change the AC07X-C module
or change the electronic
control unit AC07X
15 ALARM
SETTINGS
-
REFILL
PELLETS
wrong setting of burner output
due to low temp of flue gas in
the heat exchanger
lack of pellets in the fuel tank
For DxxPX and PXxx boilers
Change output by T4 and T6
parametres
Full up pellets
To reset error message turn
the main switch of the boiler
off and on
16 ALARM
PELLETS
-
REFILL
PELLETS
lack of pellets in the fuel tank
For DxxPX and PXxx boilers
Full up pellets
To reset error message turn
the main switch of the boiler
off and on
To Next Page
Loading...