To Next Page
C
Craig HolmesAug 16, 2025
What to do if my Atmos Medical Equipment i View PRO has no function?
- DDawn WiseAug 17, 2025
If the ATMOS® i View PRO Medical Equipment shows no function, ensure it is switched on at the connection box.
What to do if my Atmos Medical Equipment i View PRO has no function?
If the ATMOS® i View PRO Medical Equipment shows no function, ensure it is switched on at the connection box.
How to fix too little or no light on Atmos Medical Equipment i View PRO?
If the ATMOS® i View PRO Medical Equipment shows too little or no light, make sure that it is not in the parking position. Pull the ATMOS® i View PRO into the working position. Also, increase the brightness of the light source.
How to fix Atmos Medical Equipment i View PRO if it cannot be switched on?
If the ATMOS® i View PRO Medical Equipment cannot be switched on, check the mains cable and connect it. If the issue persists, exchange the fuse.
What to do if the screen displays text on my Atmos Medical Equipment i View PRO?
If the ATMOS® i View PRO Medical Equipment displays text on the screen, especially with an integrated HD camera, press the 'mode' button once.
What to do if my Atmos Medical Equipment i View PRO is hot?
If the ATMOS® i View PRO Medical Equipment gets hot, ensure sufficient air ventilation. If it continues, switch it off and let it cool down for 2-3 hours.
What to do if my Atmos i View PRO i View PRO monitor displays text?
If the ATMOS i View PRO microscope displays text on the monitor, and you have an integrated HD camera, it might be because the MODE button was pressed for too long. Try pressing the MODE button once again to resolve this.
Why is there too little or no light at all on my Atmos Microscope i View PRO?
If your ATMOS i View PRO microscope has too little or no light, first check if it was moved into the “parking position,” which switches off the light. If so, pull the ATMOS i View PRO into the working position. Also, ensure the light source brightness isn't dimmed too low; if it is, increase the brightness of the light source. For a malfunction or extreme decline of the LED light source, contact Atmos Service.
What to do if the arm follows on my Atmos i View PRO Microscope?
If the arm of your Atmos Microscope follows, it could be because the tie bar is not adjusted vertically. Try adjusting the tie bar. Alternatively, the coverings of the set screws might be worn out or not fixed in place; in this case, you should exchange or fix the extensions of the set screws.
How to fix Atmos i View PRO i View PRO that cannot be switched on?
If your ATMOS i View PRO microscope cannot be switched on, it may be due to the power cable not being connected. Ensure the power cable is properly connected. If the issue persists, the fuse may be defective and need to be exchanged.
What to do if my Atmos i View PRO i View PRO has no function?
If your ATMOS i View PRO microscope has no function whatsoever, ensure that it is switched on at the connection box.
General| Brand | Atmos |
|---|---|
| Model | i View PRO Series |
| Category | Microscope |
| Language | English |