ATN Extended Life Battery

To Next Page

QUICK START GUIDE

UNPACKING

When opening your package make

sure that all the contents are present.

You should see a rechargeable 10,000

mAh battery, a Neck/Shoulder strap to

attach to your Binocular or Monocular,

plus the USB to USB type C Cable.

NOTE:

We recommend charging the

battery for at least 10 hours before

use. You can use your computer

or a compatible wall charger (not

included), to charge the battery

initially.

The information in this manual is furnished for informational use only, is subject to change without notice,

is not to be construed as a commitment by ATN Corp.

ATN Corp. assumes no responsibility or liability for any errors or inaccuracies that may appear in this book.

EXTENDED LIFE

BATTERY PACKAGE

STEP 1

Take the USB to USB type C cable

and insert it into the provided opening

at the end of the Neck/Shoulder strap

as shown in the image.

Pull the cable all the way through

until it reaches the center of the Neck/

Shoulder strap battery holder com-

partment.

Need help?

Do you have a question about the ATN Extended Life Battery and is the answer not in the manual?

Summary

Unpacking and Initial Setup

Unpacking the Extended Life Battery Package

Verify all package contents, including the 10,000 mAh battery, Neck/Shoulder strap, and USB to USB type C cable.

Connecting the Strap Cable

Insert the USB to USB type C cable into the strap opening and pull it to the battery holder compartment.

Attaching the Neck;Shoulder Strap

Loop the strap through the device slot and plastic fastener, then adjust for a secure fit on your neck or shoulder.

Connecting and Securing the Battery

Connect the USB cable to the battery, activate it, place it in the strap compartment, and close the zipper.

Connecting Battery to Device

Expose the device's USB type C media port and insert the cable's type C plug.

Powering On the Device

Turn on your device using the external battery pack by pressing the "POWER" button.