STEP 1: Unfolding
Unfold your scooter by pulling the stem
upright.
Unfold the kickstand to support the
scooter.
Locate the folding latch and push it up
to lock the stem, add some force if
necessary. Please make sure the safety
button of the folding mechanism is
clipped and latch is locked properly.
Connect the male cable from the
headset to the female cable of the stem.
Make sure the ports are aligned properly.
Insert the headset at the top of the stem
and tighten into place with the screws
provided.
Check the screws on the handlebars to
make sure they are tight.
STEP 2: Attaching Headset STEP 3: Testing
Put the scooter on the bench, make sure
the rear wheels does not touch any
surface and can spin freely.
Verify Power Bottom: make sure that
]SYVWGSSXIVGERFITS[IVIHSRERHSǺ
by press the power bottom.
Verify Motor: The scooter is in defaulted
0MGO XEVX 2SHI [LIR WTIIH VIEGL
3KM/H the motor will be started), Spin
the wheel and then press the throttle.
The wheel should begin to spin.
Verify Brake: Press the brakes and the
wheel should stop immediately.
5
To Next Page
Loading...