[
e
][
e
]
16 17
6. Error messages and repair
The binding is not closed
(properly).
The binding pressure is
too high.
The binding pressure is
too low.
The flashing symbol indi-
cates that the toe piece bat-
tery has run down.
The flashing symbol indi-
cates that the heel unit bat-
tery has run down.
Display Cause Remedy
Step out of the binding, carefully remove any
snow, ice, dirt and foreign matter from the boot
soles and interfaces of the boot to the binding
and step back into the binding.
Step out of the binding and carefully remove
any snow, ice, dirt and foreign matter from the
boot soles and interfaces of the boot to binding
and step back into the binding. If the error
message appears again, contact a qualified
specialist dealer.
Contact a qualified specialist dealer to have the
battery changed.
7. Following the "OK" an animation will appear on the display. You can choose from one of
three options. Your choice will be set by the specialist dealer.
5.2. Opening and stepping out (also in case of emergency)
Press down the heel lever , raise your heel and step out of the binding.
ANIMATION 1
zoom in
ANIMATION 2
scroll
ANIMATION 3
rotation
8
7. Mounting and Service
For your binding to function properly, and consequently for your own safety, proper maintenan-
ce and regular service are imperative even if your binding is of high technical quality.
:: We therefore recommend that you have your binding serviced by a qualified specialist dealer
as soon as the service symbol appears.
Transport:
:: Always remove the boot from the binding before transport.
:: The binding should always be protected by a transport box, a binding cover or a ski bag when
being transported on the car roof. Remove the binding protection after transport.
Storage:
:: Always remove the boot from the binding before putting your equipment into storage.
:: Store your skis in a dry room. This helps avoid the danger of corrosion and prevents the
binding from being covered with snow or ice or being penetrated by moisture. To protect the
mechanism, it is advisable to close the heel unit.
8. Warranty/Guarantee/Liability
:: ATOMIC gives a one-year guarantee to the original buyer (final consumer) of the ski binding
calculated from the date of purchase. Within the scope of this guarantee ATOMIC Austria
GmbH will either replace or repair the faulty product or parts thereof or provide a replacement.
:: Bindings must always be mounted by an authorised specialist dealer and adjusted to the
personal settings of the customer. The setting protocol must be given to the customer who
must keep it carefully. Claims for performance under the guarantee for faulty bindings or parts
thereof will only be accepted by ATOMIC Austria GmbH if the setting values with a standard
boot sole do not fall within the tolerances of the ISO standard (wear or dirt on the ski boot
can have a serious negative effect on the binding for example).
The flashing symbol indi-
cates that the binding
needs to be serviced.
No display
Display Cause Remedy
The binding is functioning properly! However,
we recommend that you have it serviced by a
qualified specialist dealer before you go skiing
again.
Even if the Electronic Binding Management
System is no longer working, the mechanical
function of the binding is guaranteed. However,
as the system check cannot be carried out, we
recommend that you do not continue skiing.
To Next Page
Loading...