Under Configure IPV4, you can either leave the ZATO in its default state, Using DHCP, or you
can switch it over to Manual mode for a fully manual network configuration.
Next, connect your Ethernet cable to the USB-C to Ethernet adapter. If you've selected
Using DHCP in the previous step, the ZATO will automatically fetch its network configuration
parameters from the Switch/Router you're connected to. In Manual mode, you need to enter
all these parameters manually, depending on your network configuration.
You can deactivate Ethernet via the ON/OFF switch on the right side of this menu.
To Next Page
Loading...
Need help?
General
