ATOMSTACK MAKER User Manual

Precautions
When taking over the pipe, the installation position must be completely wrapped and the hose clamp should be locked.
Arrange the pipe as straight as possible (not too cued).
After replacing the lter element, the lower cover needs to be aligned with the assembly features.
The place of use and equipment should be relatively static, and should not be subject to frequent or long-term vibrations,
collisions, or shaking.
It is suitable for installation and use in a veical position. The horizontal position will have a ceain impact on the long-term
purication life of the lter element; the upside down position may not be able to guarantee the initial eect and long-term
peormance of the lter element.
Under normal circumstances, the internal and external structure of the lter element is designed to resist or withstand a
reasonable degree of impact such as collisions and extrusions during transpoation and storage; if severe collision,
extrusion, etc. cause the appearance to be dented, cracked, or damaged, or the product is shaken loose or material
scattered, it may aect the normal use eect.
It is suitable for neutral or weak acid and alkali ue gas purication; it is not suitable for strong corrosive gases or paicles
such as strong acid and alkali, otherwise it will cause obvious erosion and damage to the structure and peormance of the
lter element.
1.
2.
3.
4.
5.
6.
7.
-4-

ATOMSTACK MAKER Specifications

General

Brand	ATOMSTACK
Model	MAKER
Category	Water Filtration Systems
Language	English