Need help?Do you have a question about the ATOMSTACK M4 and is the answer not in the manual?
General| Software Compatibility | LightBurn, LaserGRBL |
|---|---|
| Cooling System | Air Cooling |
| Product Model | ATOMSTACK M4 |
| Marking Accuracy | 0.01mm |
| Output Voltage | 12V |
| Equipment Power | 60W |
| Minimum Line Width | 0.01mm |
| Connectivity | USB, WiFi |
| Supported File Formats | BMP, JPG, PNG, DXF |
| Operating Temperature | 0-35℃ |
| Operating Humidity | 20% - 80% |
| Engraving Area | 70mm x 70mm |
Guide to installing the engraving software and necessary drivers from U disk or website.
Setting marking speed, power, and initiating the marking process.
Instructions on adjusting the laser height for optimal focus using test paper and ruler.
Setting software parameters for effective carving of portrait photos.
Setting software parameters for effective carving of bitmap images.
Recommended line spacing, power, and speed settings for different materials.
Specific parameters for black/white bitmaps and colored photos on various surfaces.
To Next Page
