In the copied file,
find the BslCAD
software and follow
the prompts to
complete the
installation
After the software
installation is
complete, open
SeaCAD in the
software and start
using
Choose a
drawing
tool
Turn on the
power of the unit
and adjust the
focus
Insert the U disk
and connect
the required
computer with
the cable
Open the U disk, find the
driver
CyPressDriverlnstaller file,
copy it to the computer,
double-click to install,
and follow the prompts to
complete the installation;
Part 8：Common operating procedures of the software
draw：Lines,
curves, rectangles,
circles and
polygons
Text: Click on the
auxiliary
toolbar 。
Image: Click on
the auxiliary
toolbar 。
Vector: Click on
the auxiliary
toolbar 。
Click on the
auxiliary
toolbar 、
Edit dimensions,
etc. in the object
properties
window
Click to fill ，
Choose a fill
method“Filling”，
click
Set "Speed (mm/s)"
and "Power (%)" in
"Marker Control
Window"
Click on the
auxiliary
toolbar 、
Edit text content,
fonts, etc. in the
object properties
window and save
Click on the auxiliary
toolbar 、Import the
object to be marked, edit
the parameters such as
inversion, grayscale, DPI in
the property window and
save it
Click on the
auxiliary
toolbar 、
Click to fill ，
Adjust "Line" to
0.04MM, click
Click ，Check
the marking position and
range, if it is not suitable,
please re-adjust and edit
Click ，
start marking
Complete the marking, if
unqualified, please re-
adjust the parameters
In "Mark Configs",
select to enter
"Expand..." interface,
check "Bitmap scan
increment"
To Next Page
Loading...
