ATOMSTACK M4 - Picture Carving: Portrait Photos; Portrait Photo Import and Settings; Portrait Photo Parameter Configuration

1.Click to pop out the“Picture atribute" window. Click to select a picture and then click to confirm
picture import.
Figure 1
Image 3Figure 2 Figure 4
2.Adjust the picture to a proper size;
3.Check "Reversal, "Grayscale" and “Fixed
DPI" (enter parameter 500 for X and Y)
and“Outlets' in the Picture Settings window,
4.Check“Two-way scanning" in the“Mark
Configs" window and enter 0.4 in“Dotting
time";
5In "Mark Configs", select to enter
"Expand..." interface,check“Bitmap scan
increment"
6.Carving parameter setting.
Set“speed(mm/s)" as 500 and "power(%)"
as 100.
Notes: Carving of portrait/colored photo on paint and baking paint metal/oxidized paint electroplating metal can produce the best effects.
Figure 5
Image 6
Figure8
Part 14:Picture Processing (Portrait/Colored Photo)
Figure7