EasyManua.ls Logo

Atosa ATSP-18-1 - User Manual

Atosa ATSP-18-1
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Gas Heavy Duty Stock Pot Stove
Operating Instructions
Before you begin, please read these instructions carefully to
use this product correctly, to make the product perform ideally, and
to avoid hazards.
Models: ATSP-18-1/ ATSP-18-2
ATSP-18-1L/ ATSP-18-2L

Table of Contents

Questions and Answers

  • W
    wgonzalezJul 29, 2025
    Why is my Atosa ATSP-18-1 Stove showing yellow flame and black smoke?
    • M
      mary87Jul 29, 2025
      The yellow flame and black smoke in your Atosa Stove may be due to several reasons: * The type of gas being used is not appropriate, so you should change the gas. * The nozzle aperture does not match the gas resources, in this case you should adjust the nozzle diameter. * There is not enough air to ignite. To fix this, increase the damper opening degree. * During peak gas usage, the gas sources may be heavy. Reduce the valve flow and increase it after the peak.
  • D
    dandrewsAug 5, 2025
    What to do if Atosa ATSP-18-1 ignites pilot light but not the main fire?
    • M
      Mark RothAug 5, 2025
      If your Atosa Stove ignites the pilot light but not the main fire, consider the following: * There might be insufficient gas pressure in the pipe. Contact your local gas supply department. * The main fire nozzle may be occluded, so dredge the nozzle. * The gas control valves could be faulty. Replace the gas control valves. * The distance between the pilot light and the main fire might be too far. Adjust the distance between them. * The flame may be too low, so adjust the height of the pilot light.
  • R
    Rick LawsonAug 13, 2025
    What to do if my Atosa Stove is not lighting?
    • M
      Mallory RushAug 13, 2025
      If your Atosa Stove is not lighting, it could be due to: * Insufficient gas pressure in the pipe, in which case you should contact the local gas supply department. * Nozzle occlusion. Dredge the nozzle to resolve this.
  • V
    vanessa31Aug 20, 2025
    What to do if I close gas and hear a sound of fire in my Atosa ATSP-18-1 Stove?
    • I
      ilucasAug 20, 2025
      If you hear a sound of fire after closing the gas on your Atosa Stove, it could be due to: * Insufficient gas pressure in the pipe. Contact the local gas supply department. * The nozzle aperture not matching the gas resources, so adjust the nozzle diameter. * Insufficient flow in the connection pipe. Increase the pipe’s allowable flow. * The damper opening degree being too large, so adjust the damper.

Summary

Gas Heavy Duty Stock Pot Stove Operating Instructions

Safety Protection

Brief Introduction

Overview of the gas char broilers and their intended use.

Manufacturers Authority and Responsibility

Defines manufacturer's stance on product modifications and liability.

Parameter Specifications

Outline Dimensions

Detailed physical dimensions for various stove models.

Information of Gas Supply and Burner

Transport and Storage

Installation and Debugging

Safety Notices and Precautions

Operating Instructions

Lighting the Pilot Light

Procedure for igniting the pilot light for each burner.

Igniting the Main Burner

Steps to ignite the main burner using the pilot light.

Turn off the valve

Procedure for safely shutting down the main burners.

Stove Operation and Adjustments

Guidance on preheating, switching gas sources, and adjusting air input.

Cleaning and Maintenance

Troubleshooting Common Issues

Spare Parts Identification

Accessories List

Product Conformance and Support

Atosa ATSP-18-1 Specifications

General IconGeneral
ModelATSP-18-1
CategoryStove
TypeGas
Burners1
Burner TypeOpen Burner
MaterialStainless Steel
Gas TypeNatural Gas or Propane
Dimensions (WxDxH)18" x 27" x 12"
Burner BTU30, 000 BTU