ZERO INDICATOR ARROW appears when scale has no
weight on the weighing pan, or
when the Tare button is pressed.
TARE INDICATOR ARROW appears when Tare is pressed
while there is a weight on the weigh pan.
LACK OF SAMPLE INDICATOR ARROW appears when the
sample amount on
the weighing pan is not enough for accurate counting in
number setting mode
(see 2. SAMPLE SETTING:
a. Number setting:)
LACK OF PIECE WEIGHT INDICATOR ARROW appears
when the sample
unit weight is not heavy enough for accurate counting
operation in unit weight mode
(see 2. SAMPLE SETTING:
B. Unit weight setting:)
NUMERIC (0-9) KEYS are used for setting numerical data for
the sample number,
sample weight or alarms for quantity checking.
DECIMAL POINT (.) KEY is used for setting the decimal
position of a sample
weight.
[ZERO/MENU] KEY is to set or re-adjust the scale into the
zero position.
[TARE/DIV] KEY subtracts the gross weight that is on the
weigh pan (empty box,
container, etc.)
[SAMPLE/UNIT] KEY is used when setting the counted
sample amount on the
weigh pan into the memory of the scale.
[UNIT WEIGHT] KEY is used when setting the known unit
weight data into the scale
in normal operation.
CLEAR [CE/SET] KEY is used for cancelling the numeric
setting data, to cancel
the previous unit weight data or to cancel alarms for quantity
check.
[QUANTITY CHECK] KEY is used for switching between
normal counting and
quantity check alarm settings.
MEMORY [M+] KEY is used for the accumulation count data.
The data is
memorised by pressing this key, and can accumulate up to 99
counts.
MEMORY CANCEL [MC] KEY is used for cancelling the
memorised data.
[TOTAL] KEY is used for switching between normal counting
and memory data
recall.
To Next Page
Loading...