Atrix AHC-RR - Using the Revo Red; Initial Setup and Power; Power and Cord Management; Emptying the Dust Bin

5 | P a g e
Using the Revo Red
Before using the vacuum, pull out a sufficient
length of cord and then plug the cleaner into the
wall outlet.
The yellow mark on the cord is the maximum
length and must not be exceeded.
Push On/Off Button
To rewind the cord, push cord rewind button
Emptying the Revo Red Dust Bin
Empty the dust bin regularly, at the latest when
the quantity of dirt in the dust container has
reached the “MAX” mark or the suction power
has dropped.
• Switch off the vacuum cleaner and disconnect
the plug from the outlet. To do this, always pull
on the plug and not on the cord.
• Release the dust container by pressing down
the release button (1).
• Lift the dust container forwards out of the
cylinder vacuum cleaner (2).
• When emptying the dust container, hold it low
over the garbage can.
• Press the open button. The base opens and the
dust drops (3).
• Carefully knock the remaining dust loose.
• Close the base.
• Place the dust bin back onto the vacuum
cleaner.
• Check whether the dust container is securely
seated.