Need help?Do you have a question about the Atronic JCM UBA-10-SS and is the answer not in the manual?
General| Type | Bank Note Validator |
|---|---|
| Model | UBA-10-SS |
| Currency Support | Multi-currency |
| Power Supply | 12V DC |
| Operating Voltage | 12V DC |
| Interface | Serial |
| Acceptance Rate | 98% or greater |
Lists and illustrates the physical parts of the JCM UBA-10-SS bill acceptor.
Highlights the primary functionalities and technological advantages of the bill acceptor.
Details the electrical voltage and current specifications for operating the unit.
Specifies the maximum number of banknotes the cash box can store.
Defines the time taken from bill insertion to completion of stacking.
Lists the acceptable width and length dimensions for banknotes.
Outlines the recommended temperature and humidity ranges for operation and storage.
Provides the overall weight of the bill acceptor unit.
Step-by-step instructions for accessing and removing collected banknotes.
Procedure for detaching the transport unit for maintenance or clearing jams.
Instructions for removing jammed bills from the transport unit or cashbox.
Guidance on the schedule and conditions for performing maintenance tasks.
Steps for visually examining the bill acceptor for debris, wear, or damage.
Instructions on how to clean internal components like belts, lenses, and rollers.
Step-by-step guide for updating the bill acceptor firmware using a PC.
Details LED error codes indicating malfunctions, with causes and solutions.
Explains LED codes associated with bill rejections and their troubleshooting.
Addresses common faults where the acceptor fails to accept any bills.
Provides solutions for recurring problems causing bills to jam.
Offers troubleshooting steps for improving the bill acceptance accuracy.
Solutions for when the upper guide mechanism cannot be opened.
Troubleshooting guide for scenarios where the acceptor rejects all banknotes.
Addresses issues where the internal motor runs without stopping.
Troubleshooting steps for communication problems between the acceptor and host.
Check which bill denominations are enabled or disabled by the host machine.
Test bill acceptance and stacking functionality with banknotes.
Test bill acceptance where bills are rejected after validation.
Details the pin assignments and functions for the main UBA-10 interface connector.
Outlines the pin assignments and functions for the front bezel connector.
To Next Page