Rev: 9.27.18
ALWAYS use proper safety precautions: Wear eye protection and use nitrile or latex gloves at all times.
Have a fire extinguisher available in the area. Run the vehicle outside or in a well ventilated area. The 3C will
start and stop automatically. To manually stop the 3C mid-cleaning push the Emergency Stop Switch located
on the front panel. Before performing a cleaning with the 3C check the vehicle’s engine oil and coolant levels
and top off if needed. If the vehicle’s engine is making any unusual noise check and repair prior to cleaning.
Check for both pending and hard DTC’s. Always use common sense when using the 3C system.
FOR PROFESSIONAL USE ONLY
If you need help or have questions call ATS at (800) 572-6112 for assistance.
This technology has been under development for over 4 years. It is extremely important to follow these directions.
ATS cannot be responsible for any action taken by a shop or technician that is not stated in the following information.
Doing any procedure that is not specifically stated by ATS is at the users own risk.
DO NOT USE THE 3C INDUCTION CLEANER ON ANY EXOTIC ENGINES such as, but not limited to;
Ferrari, Maserati, McLaren, Bugatti, Koenigsegg, Lamborghini, etc. Additionally Do not Clean
BMW N63-S63 V8 Twin Turbo engines
Getting to know your 3C
Air Bleed
Valve
Chemical
Reservoir A
Chemical
Reservoir B
Chemical
Reservoir C
Compressed
Air Plug
Emergency
Stop Switch
Manual
Chemical
Shut Off
Start
Clean
Button
Intake
Adapter
Hoses
Cylinder
Selection
Switch
Chemical PSI
Air PSI
Arm/Disarm
Button
Holding
Clamp
Battery
Leads
2 Amp
fast-blow fuse
Injection Nozzle
3C Cleaning
Hose Assembly
3C Intelligent Induction Cleaner Quick Start Guide
Patent Pending
TM
To Next Page
Need help?
General
