Possible defects and their remedy
Defect
Remedy
There is no voltage in the main
Cord damaged
Check
Check
Replace
Replace
The boiler cannot reach
demanded parameters
Lack of water in system
Bad quality of fuel
Mistake in project
New chimney, remove wrong attachment
Door not sealed
Damaged packing cord
Replace
See the supplement No.1, Or No.2 -
Searching defects
The light "burner switch"
is not lighting
No need of heating
Interrupted safety
thermostat
Damaged switch
Find the cause, remove it and then reset
Replace
19
Cause
Control light "power net"
is not lighting
Plug is not plugged properly
Damaged switch
Too high pump output
Boiler output is not
dimensioned sufficiently
for the system
Weak chimney drought
Strong chimney drought
Defect of the burner
Re-fill
Regulate the flow and switching
Use the prescribed fuel only
Place a cut-off slide into exhaust
pipe
, set up the hinges
To Next Page
Loading...
