Before cleaning the burner from ash it is necessary:
- To turn off the heating requirement by switching off the
burner switch. The fan stays in operation for approx. 4
minutes (burning out phase).
- To switch off the main switch on boiler control board after
the fan stops (cca 4 min.) and let the burner cool down to
avoid scorching.
- To remove the fitting screws (eventually open the door
where the burner is installed -it depends on boiler
modification) and remove the burner from the boiler.
- To remove the grate and clean it.
- Clean the burner carefully and also the boiler - if
necessary, from the soft and hard ash.
- Clean the ignition plate and its openings very carefully
from soft and hard ash.
Push the plane part back of the grate back under the
ingition plate as far as possible.
Clean the photocell if necessary.
- remove the photocell
- clean the photocell from the soot using the wet clout
- check the location of clamping ring on the photocell
put the photocell in again
NOTE:
CAUTION: Use the protecting gloves and
eyeglasses during soft and hard ash removal!
Cleaning/checking of photocell :
-
CAUTION: It is necessary to disconnect the
Ignition
Plate
grate
photocell
appliance from the main and remove the control board before eventual welding on the
appliance.
Maintenance schedule
1. 2-4 times per month (regarding pellet quality):
remove the soft and hard ash
2. 1 time per month: clean the falling shaft and tube
3. 1 time per month: clean the flue channels (moving the pull-rod of turbulators) and
convective parts of the boiler
(the more frequently, the higher efficiency).
4. 1 time per quater: Clean the storage for pellets from saw dust
5. 1 time per year: Check the burner settings with the appropriate appliances
(contact your seller or installer).
!
!
10
To Next Page
Loading...
