To Next PageTo Next PageWhat to do if the Atwood LPCO end of life alarm indicates the alarm is non functioning?
If the end of life alarm indicates that the Atwood Security System alarm is non functioning, you must replace the alarm. It is not field reparable.
Alerts users to potential safety hazards and emphasizes following safety messages.
Indicates insufficient power; indicators and button are inactive.
Gas concentrations monitored at safe levels; Power LED lit.
Gas concentrations are unsafe; Power, CO, or LP indicators lit.
Test function initiated; all visual indicators lit, audible alarm sounds.
Alarm stabilizing after power-up or reset; Power LED flashing.
A fault detected that compromises alarm function; Fault LED on.
Detector has reached 7 years of operation; sensors no longer reliable.
Instructions for mounting using a 120 VAC wall outlet adapter.
Procedure to test alarm operation weekly.
Alarm activates when LP gas exceeds 2000 ppm.
Available voltage between 10-8 VDC; LED flashes orange.
Voltage between 8-6 VDC; detector conserves power, chirps, flashes red/orange.
Voltage below 6 VDC; LED steady red; detector not sensing gas.
No power applied or power circuit failure; LED shows no indication.
Alerts users to potential safety hazards and emphasizes following safety messages.
Indicates insufficient power; indicators and button are inactive.
Gas concentrations monitored at safe levels; Power LED lit.
Gas concentrations are unsafe; Power, CO, or LP indicators lit.
Test function initiated; all visual indicators lit, audible alarm sounds.
Alarm stabilizing after power-up or reset; Power LED flashing.
A fault detected that compromises alarm function; Fault LED on.
Detector has reached 7 years of operation; sensors no longer reliable.
Instructions for mounting using a 120 VAC wall outlet adapter.
Procedure to test alarm operation weekly.
Alarm activates when LP gas exceeds 2000 ppm.
Available voltage between 10-8 VDC; LED flashes orange.
Voltage between 8-6 VDC; detector conserves power, chirps, flashes red/orange.
Voltage below 6 VDC; LED steady red; detector not sensing gas.
No power applied or power circuit failure; LED shows no indication.
General| Brand | Atwood |
|---|---|
| Model | LPCO |
| Category | Security System |
| Language | English |
