POWER SUPPLY AND POWER CORD REQUIREMENTS
Power supply class I grounding requirements:
For protection from fault currents, the equipment shall be connected to
a grounding terminal. Plug the system power cord into an AC outlet that
provides a ground connection. Substitute cords may not provide adequate
fault protection. Only use the power cord supplied with this product or
an authorized/equivalent replacement
Safety notices:
Denmark:
Apparatets stikprop skal tilsluttes en stikkontakt med jord, som
giver forbindelse til stikproppens jord.
Finland:
Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
Norway:
Apparatet må tilkoples jordet stikkontakt.
Sweden:
Apparaten skall anslutas till jordat uttag.
ATTENTION
The fuse (T500mAL/250V) provides a safeguard function to the device.
When replacing the fuse, make sure that the value of the replacement
matches the value of the original fuse. Identification of a suitable
replacement component or substitute shall be done by qualified
technicians.
To Next Page
Loading...