Audi A5 2024 - Entry;Exit Lighting

8W7012721BH
Lights and vision
— The headlight contains a class 2 laser. The
technical design converts the laser beam so
that there is no danger when it is used for
its intended purpose.
~The laser beam emission from the head-
lamp has been classified in accordance with
IEC 60825-1:2007.
~The possible emission is below the thresh-
old for laser class 2.
~ Maximum laser beam output: SW (continu-
ous emission), wavelength range A= 400 nm
-700 nm.
= The headlamp light functions are rated in
accordance with IEC 62471-5:2015.
~The beam emitted from the headlamp was
classified as risk group 2.
Adjusting the exter!
The following settings depend on the vehicle
equipment.
> Applies to: MMI: Select on the home screen:
VEHICLE > Light & Visibility > Exterior light-
ing
Automatic headlights
You can adjust the following settings in the Auto-
matic
headlights menu:
Activation time - You can adjust if the headlights
switch on Early, Medium, or Late based on the
sensitivity of the light sensor.
High beam assistant - You can switch the high
beam assistant on and off.
Laser lights - You can switch the laser lights on
and off.
Entry/exit lighting
The Entry/exit lighting illuminates the area
around the vehicle when the vehicle is unlocked
or when the driver's door is opened while the ig-
nition is off, The entry/exit lighting works when it
is dark and the light switch is in the AUTO posi-
tion. The daytime running lights switch on auto-
matically each time the vehicle is unlocked, re-
gardless of how bright it is outside the vehicle.
Daytime running lights
USA models: The daytime running lights can be
switched on and off.
Canada models: This function cannot be switched
off. They activate automatically each time the ig-
nition is switched on.
Emergency flashers
Fig. 57 Center console: emergency flashers
The emergency flashers help to make other road
users aware of your vehicle in dangerous situa-
tions.
» Press the A @ button to switch the emergency
flashers on or off.
When the emergency flashers are turned on, the
Eland BJ indicator lights will flash at the same
time.
You can indicate a lane change or a turn when the
emergency flashers are switched on by using the
turn signal lever. The emergency flashers stop
temporarily.
The emergency flashers also work when the igni-
tion is turned off.
You should switch the emergency flashers on
if:
—you are the last car ina traffic jam so that
all other vehicles approaching from behind
can see your vehicle
—your vehicle has broken down or you are
having an emergency
—your vehicle is being towed or if you are tow-
ing another vehicle
65
OwnersManuals2.com