Audi A6 Quattro 2008 User Manual

Accessories and Body, Cab
Body Collision Repair
01 - BODY COLLISION REPAIR - GENERAL INFORMATION
SAFETY INSTRUCTIONS
--> Removing Components
--> Battery, Welding Procedures
--> Electronic Control Modules
--> Paint, Glass, Upholstery, Trim
--> Fuel Tank or Fuel Lines
--> Air Conditioning
--> Airbag System
--> Seat Belts, Inspecting
--> Working on Vehicles with Belt Tensioners
--> Separating Work, Straightening Work and/or Dent Removal on Vehicles with Airbags
--> Seats with Side Airbags, Removing
Removing Components
The vehicle must be secured on the hoist before its center of gravity changes due to disassembly.
Battery, Welding Procedures
Before welding, you must disconnect both battery terminals and cover both battery poles.
You must remove the vehicle battery before performing work near the battery that could produce sparks.
NOTE:
 Before disconnecting battery ensure that radio code is available. Ensure
radio is in an operational condition by inputting radio code before
releasing vehicle to customer.
CAUTION: Switch off ignition before connecting battery! --> 27
- STARTER,
GENERATOR, CRUISE CONTROL
2008 Audi A6 Quattro
Accessories and Body, Cab Body Collision Repair
2008 Audi A6 Quattro
Accessories and Body, Cab Body Collision Repair
FIXYOURCAR
1:34:58 AM Page 1
FIXYOURCAR
1:35:03 AM Page 1

Audi A6 Quattro 2008 Specifications

General

Brand	Audi
Model	A6 Quattro 2008
Category	Automobile
Language	English