Bluetooth®
Pairing
Initial
Setup
Bluetooth
pairing is a one-time procedure. Once
paired via
Bluetooth,
your phone will automatically
connect
when
you start your vehicle and your
phone's contacts automatically synchronize,
allowing you to retrieve contacts and make and
receive calls through the infotainment system. For
more information regarding phone compatibility
visit audiusa.com/bluetooth.
1. Switch ignition to accessories mode.
2.
Activate your phone's Bluetooth function and set
to pairing or search mode.
3. Select Audi MMI when it appears on the phone's
screen.
4.
Use the MMI control knob to select Yes.
5. Confirm the six-digit PIN displayed matches the
PIN displayed on your phone, and select Yes.
6. Select Pair on your phone to complete the
pairing process.
Contacts synchronizing.
Bluetooth active and network strength bars.
Some phones may require
a
response
to
automatically
connect
for
future
connections. Once paired, the Bluetooth
symbol appears on the MMI screen along with network
strength bars and it will
be
displayed whenever
a
paired
phone is connected
to
the
infotainment
system.
Learn more about
Bluetooth Pairing
TEXT A7PAIR16A
to
38981
Do not text and drive.
Message and
data
rates may apply.
Read Messages
Your Audi vehicle's Bluetooth system can allow
you
to get
text messages that are sent
to
your cellular
phone from the MMI System.
1. Establish Bluetooth connection.
2. Configure your mobile phone. Select option 2a
or
2b
depending on your device.
2a.
For iPhone, enable Show Notifications
from Bluetooth properties of your
connection.
iPhone Dial*.
Messages
}
Enter number
1 f^K) Recent calls
^
C
Directory
D
F?
3
Favorites
ygj
Voicemail
AT&T
Settings
Note:
Bluetooth® Pairing
See
your phone’s Owner's Manual for specific Bluetooth activation instructions. Vehicle must
be
stationary with the parking brake engaged while
performing this operation. Once paired, the Bluetooth symbol appears in the MMI screen along with network strength bars and it will be displayed
whenever a paired phone is connected
to
the infotainment system.
Important Safety Instructions and Warnings: Bluetooth® Pairing
Medical experts warn that cell phones can interfere with the function of pacemakers. Always maintain
a
minimum distance of 20 centimeters
between the cell phone antenna and the pacemaker.
Do not carry the cell phone in
a
pocket directly over the pacemaker when the phone is switched on.
Switch the cell phone off immediately if
you suspect
it may
be
interfering with the pacemaker.
Do not
use
the Voice Recognition system in emergencies
because
your voice may change in stressful situations. It may take longer
to
dial the
number or the system may not
be
able
to
dial it
at
all. Dial the emergency number manually.
Switch your cell phone off in areas where there is
a
risk of an explosion. These locations are not always clearly marked. This may include
gas
stations, fuel and chemical storage facilities or transport vehicles, or locations where fuel vapors (such
as
propane or gasoline vapor in vehicles or
buildings), chemicals or large quantities of
dust
particles (such
as
flour, sawdust or metal) may
be
present in the air. This also applies
to
all other
locations where
you
would normally turn your vehicle engine off.
The demands of traffic require your full attention.
Obey
all applicable laws regarding
use
of telephones in vehicles.
Switch off the telephone where
use
of cell phones is prohibited.
Obey
all applicable notices and regulations.
Important Safety
Instructions and Warnings:
Voice
Recognition
Direct your full attention
to
driving. As the driver,
you
have complete responsibility for safety in traffic. Only
use
the functions in such
a
way that
you
always maintain complete control over your vehicle in all traffic situations.
Do not
use
the Voice Recognition system in emergencies
because
your voice may change in stressful situations. It may take longer
to
dial the
number or the system may not
be
able
to
dial it
at
all. Dial the emergency number manually.
Bluetooth®
&
Voice Recognition
To Next Page
Loading...
