Audi A7 2023 - Distance Warning

4K8012721BK
Driver assistance
adaptive cruise assist is adjusting the speed in a
narrow area, for example a construction zone.
Adaptive cruise assist: Please take over!
Adaptive cruise assist was ended, for example be-
cause the vehicle rolled backwards when starting
on a slight incline even though the system was.
active. You must take over further control of the
vehicle.
Adaptive cruise assist: limited availability.
See owner's manual
This message appears when the sensor view is,
limited, for example, when weather conditions
are too poor or a sensor is covered. You can
switch on the adaptive cruise assist, but certain
functions such as assistance in narrow areas will
not be available. Under certain circumstances,
some objects may be detected late or may not be
detected at all. Be especially careful. Cleaning
the area in front of the sensors page 122 may
correct the malfunction.
Distance warning
Description
Applies to: vehicles with dista ing
Applies to: vehicles with adaptive cruise assist
Fig. 100 Instrument cluster: display of the current dis-
tance
Applies to: vehicles with adaptive cruise assist:
Fig. 101 Instrument cluster: distance warning
General information
At speeds above approximately 40 mph (65
km/h), this function measures the distance to
the vehicle ahead as time. If the distance falls be-
low the warning threshold and remains there,
the system will warn you of the hazard with the
BB indicator tight.
Image in the Driver assistance display
Applies to: vehicles with adaptive cruise assist
The display only appears if the Driver assistance
display is selected on the on-board computer
© page 16 and the adaptive cruise assist is not
actively controlling the vehicle.
@ Detected vehicle driving ahead
@® Use the markings to help you estimate the
distance to an obstacle. Each marking repre-
sents approximately one second.
© Set warning threshold. Depending on the set-
tings, the display will be colored in from the
bottom to the top.
@ The actual distance is smaller than the set
distance and you will be informed about the
danger.
Adjusting the distance warning
You can switch the system on and off in the MMI
page 123
You can adjust the distance warning to your pref-
erences. The settings depend on the vehicle
equipment.
~ Applies to MMI: Select on the home screen: VE-
HICLE > Driver assistance > (3) > Distance
warning
Possible settings:
~— Warning threshold
Messages
tf Bj or Bis displayed when there is a malfunc-
tion, the distance warning functions may be un-
available or may be limited.
A message that indicates the cause and possible
solution
may appear with some displays. The
weather conditions may be too poor or a sensor
may be covered. Clean the area in front of the >
145