Audi A7 2023 - Page 73

4K80127218K
Sitting correctly and safely
rivets on clothing in the area where the safety
belt is worn. Otherwise, the safety belt could
be damaged.
Fastening and unfastening safety belts
Fig. 57 Releasing the belt buckle from the belt latch
Observe the safety precautions > page 69.
Fastening the safety belt
» Pull the safety belt by the belt buckle evenly
across your chest and lap.
» Insert the belt buckle in the belt latch belong-
ing to the seat until it audibly engages
fig. 56.
> Pull on the belt to make sure that the belt is se-
curely locked in the latch.
Unfastening the safety belt
» Press the red button on the belt latch fig. 57.
The belt buckle will pop out.
» Guide the belt back by hand so that the safety
belt can roll up more easily.
Safety belt monitoring system
E- if the indicator light turns on or flashes, a
front safety belt is not fastened or it has been un-
fastened while driving. There may be additional
audible warning signals.
Depending on the equipment, the safety belts in
the rear may also be monitored using the follow-
ing indicator lights:
- If this indicator light turns on, the safety
belt for the corresponding rear seat is not fas-
tened.
EB- if this indicator light turns on, the safety
belt for the rear seat has been fastened.
EA. if this indicator light turns on, the safety
belt for the rear seat has been fastened. If the in-
dicator light flashes, a safety belt in the rear is.
not fastened or has been unfastened while the
vehicle is in motion.
Adjusting the height of the safety belt
1846-0004]
Fig. 58 Belt height adjustment for the front seats - safety
belt relay
» To move the belt higher, slide the safety belt re-
lay @ upward.
» To move the belt lower, press the release but-
ton @ and slide the safety belt relay @) down-
ward.
» To check if the safety belt relay is securely
locked in place, pull firmly on the belt.
You can also adjust the height of the front
seats to change the position of the safety
belts.
71